This lever bar to act on the motor platform was surprisingly tricky.

The sequence was:

• Move the inner circlip to the centre of the shaft.
• Leave the outer rubber(?) sleeve on
• Remove the inner rubber sleeve (on the left as you look at the photo
• Insert bar into the left hand hole and then manipulate so that it comes back to align with outer hole on the right
• Push rubber sleeve ove the left hand end of rod (helps to warm a little)
• Using the bar, order push it so the sleeve is in the recess of the bar
• Slide bar back into position to align with outer hole.
• Fit washer and circlip on inner part of bar (right hand of the bar but inside)
• Gently tap the bar from the left to drift into the 2 holes until fully home. I used a silicone grease to assist this assembly.
• Fit outer washer and circlip.
• I think that is how it went!!